Reuse & Permissions

It is not necessary to obtain permission to reuse this article or its components as it is available under the terms of the Creative Commons Attribution 4.0 International license. This license permits unrestricted use, distribution, and reproduction in any medium, provided attribution to the author(s) and the published article's title, journal citation, and DOI are maintained. Please note that some figures may have been included with permission from other third parties. It is your responsibility to obtain the proper permission from the rights holder directly for these figures.

Export citation

Export citation

Choose format for download:

Download Citation
  • Open Access
  • Access by Xinjiang University

Structure of turbulent channel flow subjected to simultaneous inlet turbulence and localized injection

Masoud Asadi, Md. Kamruzzaman, and R. Jason Hearst*

  • Norwegian University of Science and Technology, Department of Energy and Process Engineering, NO-7491 Trondheim, Norway

  • *jason.hearst@ntnu.no

Phys. Rev. Fluids 7, 124602 – Published 12 December, 2022

DOI: https://doi.org/10.1103/PhysRevFluids.7.124602

Abstract

The combined effects of inlet turbulence and localized injection on turbulent channel flow are investigated experimentally in an air channel. A porous plate was used to locally inject air streams at the bottom wall of the channel, while an active grid at the inlet of the channel generated different inlet turbulence intensities. Six different wall boundary conditions as well as four different inlet turbulence cases were investigated with planar particle image velocimetry measurements above the injection zone and farther downstream of it. The results show that, above the injection zone, the mean velocity and all Reynolds stress components are significantly altered by the localized injection forming an affected layer (AL), while the inlet turbulence only intensifies the streamwise fluctuations. The AL is then transported away from the wall, and the results indicate that the inlet turbulence slightly facilitates this process by increasing the turbulence transport inside the channel. The measurement results at the downstream position show that the effects of the injection are still present in the flow; however, the AL is transported farther away from the wall to the outer layer. Turbulence structure analysis reveals that the inlet turbulence effects, such as amplifying intense streamwise fluctuations and increasing the contributions of different quadrant events to the total Reynolds shear stress, are more prominent in the central regions of the channel. On the other hand, above the injection zone, the localized injection was found to significantly affect the distribution of the fluctuations and quadrant contributions in the near-wall regions. The same effects, although less prominent, are still present at the downstream position yet only in the outer layer. Also, the inlet turbulence does not affect the inclined features of the internal boundary layer, while the localized injection slightly increases their inclination angle.

View figure in article

Physics Subject Headings (PhySH)

Article Text

References (52)

  1. S. Dey and T. K. Nath, Turbulence characteristics in flows subjected to boundary injection and suction, J. Eng. Mech. 136, 877 (2010).
  2. S. Dey, S. Sarkar, and F. Ballio, Double-averaging turbulence characteristics in seeping rough-bed streams, J. Geophys. Res.: Earth Surf. 116, F03020 (2011).
  3. M. A. A. Faruque and R. Balachandar, Seepage effects on turbulence characteristics in an open channel flow, Can. J. Civ. Eng. 38, 785 (2011).
  4. A. Singha, M. A. Al Faruque, and R. Balachandar, Vortices and large-scale structures in a rough open-channel flow subjected to bed suction and injection, J. Eng. Mech. 138, 491 (2012).
  5. D. Cao, Y.-M. Chiew, and S.-Q. Yang, Injection effects on sediment transport in closed-conduit flows, Acta Geophysica 64, 125 (2016).
  6. H. Choi, P. Moin, and J. Kim, Active turbulence control for drag reduction in wall-bounded flows, J. Fluid Mech. 262, 75 (1994).
  7. E. Mori, M. Quadrio, and K. Fukagata, Turbulent drag reduction by uniform blowing over a two-dimensional roughness, Flow, Turbul. Combust. 99, 765 (2017).
  8. M. Abbassi, W. Baars, N. Hutchins, and I. Marusic, Skin-friction drag reduction in a high-Reynolds-number turbulent boundary layer via real-time control of large-scale structures, Int. J. Heat Fluid Flow 67, 30 (2017).
  9. X. Q. Cheng, Z. X. Qiao, X. Zhang, M. Quadrio, and Y. Zhou, Skin-friction reduction using periodic blowing through streamwise slits, J. Fluid Mech. 920, A50 (2021).
  10. R. Baker and B. Launder, The turbulent boundary layer with foreign gas injection—I. Measurements in zero pressure gradient, Int. J. Heat Mass Transf. 17, 275 (1974).
  11. J. A. Schetz and B. Nerney, Turbulent boundary layer with injection and surface roughness, AIAA J. 15, 1288 (1977).
  12. M. Sano and N. Hirayama, Turbulent boundary layers with injection and suction through a slit: 1st report, mean and turbulence characteristics, Bull. JSME 28, 807 (1985).
  13. J. Park and H. Choi, Effects of uniform blowing or suction from a spanwise slot on a turbulent boundary layer flow, Phys. Fluids 11, 3095 (1999).
  14. P.-Å. Krogstad and A. Kourakine, Some effects of localized injection on the turbulence structure in a boundary layer, Phys. Fluids 12, 2990 (2000).
  15. S.-H. Park, I. Lee, and H. J. Sung, Effect of local forcing on a turbulent boundary layer, Exp. Fluids 31, 384 (2001).
  16. Y.-S. Park, S.-H. Park, and H. J. Sung, Measurement of local forcing on a turbulent boundary layer using PIV, Exp. Fluids 34, 697 (2003).
  17. L. Keirsbulck, L. Labraga, and M. Haddad, Influence of blowing on the anisotropy of the Reynolds stress tensor in a turbulent channel flow, Exp. Fluids 40, 654 (2006).
  18. M. Haddad, L. Labraga, and L. Keirsbulck, Turbulence structures downstream of a localized injection in a fully developed channel flow, J. Fluids Eng. 128, 611 (2006).
  19. Y. Kametani, K. Fukagata, R. Örlü, and P. Schlatter, Effect of uniform blowing/suction in a turbulent boundary layer at moderate Reynolds number, Int. J. Heat Fluid Flow 55, 132 (2015).
  20. W. Willmarth and S. Lu, Structure of the Reynolds stress near the wall, J. Fluid Mech. 55, 65 (1972).
  21. M. F. Blair, Influence of free-stream turbulence on turbulent boundary layer heat transfer and mean profile development, part I—experimental data, J. Heat Transfer 105, 33 (1983).
  22. P. E. Hancock and P. Bradshaw, The effect of free-stream turbulence on turbulent boundary layers, J. Fluids Eng. 105, 284 (1983).
  23. P. E. Hancock and P. Bradshaw, Turbulence structure of a boundary layer beneath a turbulent free stream, J. Fluid Mech. 205, 45 (1989).
  24. I. P. Castro, Effects of free stream turbulence on low Reynolds number boundary layers, J. Fluids Eng. 106, 298 (1984).
  25. K. A. Thole and D. G. Bogard, High freestream turbulence effects on turbulent boundary layers, J. Fluids Eng. 118, 276 (1996).
  26. N. S. Sharp, S. Neuscamman, and Z. Warhaft, Effects of large-scale free stream turbulence on a turbulent boundary layer, Phys. Fluids 21, 095105 (2009).
  27. E. Dogan, R. E. Hanson, and B. Ganapathisubramani, Interactions of large-scale free-stream turbulence with turbulent boundary layers, J. Fluid Mech. 802, 79 (2016).
  28. E. Dogan, R. J. Hearst, R. E. Hanson, and B. Ganapathisubramani, Spatial characteristics of a zero-pressure-gradient turbulent boundary layer in the presence of free-stream turbulence, Phys. Rev. Fluids 4, 084601 (2019).
  29. R. J. Hearst, E. Dogan, and B. Ganapathisubramani, Robust features of a turbulent boundary layer subjected to high-intensity free-stream turbulence, J. Fluid Mech. 851, 416 (2018).
  30. R. J. Hearst, C. M. de Silva, E. Dogan, and B. Ganapathisubramani, Uniform-momentum zones in a turbulent boundary layer subjected to freestream turbulence, J. Fluid Mech. 915, A109 (2021).
  31. Y. Jooss, L. Li, T. Bracchi, and R. J. Hearst, Spatial development of a turbulent boundary layer subjected to freestream turbulence, J. Fluid Mech. 911, A4 (2021).
  32. X. Wu, J. M. Wallace, and J.-P. Hickey, Boundary layer turbulence and freestream turbulence interface, turbulent spot and freestream turbulence interface, laminar boundary layer and freestream turbulence interface, Phys. Fluids 31, 045104 (2019).
  33. J. You and T. A. Zaki, Conditional statistics and flow structures in turbulent boundary layers buffeted by free-stream disturbances, J. Fluid Mech. 866, 526 (2019).
  34. J. You and T. A. Zaki, Turbulent heat-transfer enhancement in boundary layers exposed to free-stream turbulence, Flow, Turbul. Combust. 104, 381 (2020).
  35. M. Kozul, R. J. Hearst, J. P. Monty, B. Ganapathisubramani, and D. Chung, Response of the temporal turbulent boundary layer to decaying free-stream turbulence, J. Fluid Mech. 896, A11 (2020).
  36. M. Asadi, M. Kamruzzaman, and R. J. Hearst, The effect of inlet turbulence on the quiescent core of turbulent channel flow, J. Fluid Mech. 935, A37 (2022).
  37. M. A. Miller, A. Martin, and S. C. C. Bailey, Investigation of the scaling of roughness and blowing effects on turbulent channel flow, Exp. Fluids 55, 1675 (2014).
  38. C. G. Borchetta, A. Martin, and S. C. C. Bailey, Examination of the effect of blowing on the near-surface flow structure over a dimpled surface, Exp. Fluids 59, 36 (2018).
  39. A. M. Hamed, C. E. Nye, and A. J. Hall, Effects of localized blowing on the turbulent boundary layer over 2D roughness, Exp. Fluids 62, 163 (2021).
  40. Y. Marchenay, F. Chedevergne, and M. Olazabal Loumé, Modeling of combined effects of surface roughness and blowing for Reynolds-averaged Navier–Stokes turbulence models, Phys. Fluids 33, 045116 (2021).
  41. J. P. Monty, Developments in smooth wall turbulent duct flows, Ph.D. thesis, University of Melbourne, 2005.
  42. R. Vinuesa, A. Noorani, A. Lozano-Durán, G. K. E. Khoury, P. Schlatter, P. F. Fischer, and H. M. Nagib, Aspect ratio effects in turbulent duct flows studied through direct numerical simulation, J. Turbul. 15, 677 (2014).
  43. R. Vinuesa, P. Schlatter, and H. M. Nagib, Secondary flow in turbulent ducts with increasing aspect ratio, Phys. Rev. Fluids 3, 054606 (2018).
  44. K. A. Flack, M. P. Schultz, and W. B. Rose, The onset of roughness effects in the transitionally rough regime, Int. J. Heat Fluid Flow 35, 160 (2012).
  45. J. V. Larssen and W. J. Devenport, On the generation of large-scale homogeneous turbulence, Exp. Fluids 50, 1207 (2011).
  46. R. J. Hearst and P. Lavoie, The effect of active grid initial conditions on high Reynolds number turbulence, Exp. Fluids 56, 185 (2015).
  47. A. Sciacchitano, D. R. Neal, B. L. Smith, S. O. Warner, P. P. Vlachos, B. Wieneke, and F. Scarano, Collaborative framework for PIV uncertainty quantification: comparative assessment of methods, Meas. Sci. Technol. 26, 074004 (2015).
  48. B. Wieneke, PIV uncertainty quantification from correlation statistics, Meas. Sci. Technol. 26, 074002 (2015).
  49. M. Lee and R. D. Moser, Direct numerical simulation of turbulent channel flow up to Reτ5200, J. Fluid Mech. 774, 395 (2015).
  50. J. Jiménez, S. Hoyas, M. P. Simens, and Y. Mizuno, Turbulent boundary layers and channels at moderate Reynolds numbers, J. Fluid Mech. 657, 335 (2010).
  51. J. M. Wallace, Quadrant analysis in turbulence research: history and evolution, Annu. Rev. Fluid Mech. 48, 131 (2016).
  52. K. T. Christensen and R. J. Adrian, Statistical evidence of hairpin vortex packets in wall turbulence, J. Fluid Mech. 431, 433 (2001).

Outline

Information

Sign In to Your Journals Account

Filter

Filter

Article Lookup

Enter a citation