- Access by Xinjiang University
Viscous free-surface flows on rotating elliptical cylinders
Phys. Rev. Fluids 2, 094005 – Published 22 September, 2017
DOI: https://doi.org/10.1103/PhysRevFluids.2.094005
Abstract
The flow of liquid films on rotating discrete objects having complicated cross sections is encountered in coating processes for a broad variety of products. To advance fundamental understanding of this problem, we study viscous free-surface flows on rotating elliptical cylinders by solving the governing equations in a rotating reference frame using the Galerkin finite-element method. Results of our simulations agree well with Hunt's maximum-load condition [Hunt, Numer. Methods Partial Differ. Eqs. 24, 1094 (2008)], which was obtained in the absence of surface tension and inertia. The simulations are also used to track the transient behavior of the free surface. For cylinder aspect ratios, cylinder rotation results in a droplike liquid bulge hanging on the upward-moving side of the cylinder. This bulge shrinks in size due to surface tension provided that the liquid load is smaller than a critical value, leaving a relatively smooth coating on the cylinder. A decrease in cylinder aspect ratio leads to larger gradients in film thickness, but enhances the rate of bulge shrinkage and thus shortens the time required to obtain a smooth coating. Moreover, with a suitably chosen time-dependent rotation rate, more liquid can be supported by the cylinder relative to the constant-rotation-rate case. For cylinders with even smaller aspect ratios, film rupture and liquid shedding may occur over the cylinder tips, so simultaneous drying and rotation along with the introduction of Marangoni stresses will likely be especially important for obtaining a smooth coating.
Physics Subject Headings (PhySH)
Article Text
References (17)
- H. K. Moffatt, Behaviour of a viscous film on the outer surface of a rotating cylinder, J. de Mécanique 16, 651 (1977).
- V. V. Pukhnachev, Motion of a liquid film on the surface of a rotating cylinder in a gravitational field, J. Appl. Mech. Tech. Phys. 18, 344 (1977).
- M. A. Kelmanson, Theoretical and experimental analyses of the maximum-supportable fluid load on a rotating cylinder, J. Eng. Math. 29, 271 (1995).
- P. L. Evans, L. W. Schwartz, and R. V. Roy, Steady and unsteady solutions for coating flow on a rotating horizontal cylinder: Two-dimensional theoretical and numerical modeling, Phys. Fluids 16, 2742 (2004).
- L. Preziosi and D. D. Joseph, The run-off condition for coating and rimming flows, J. Fluid Mech. 187, 99 (1988).
- B. G. Zhang, D. E. Myers, G. G. Wallace, M. Brandt, and P. F. Choong, Bioactive coatings for orthopaedic implants-recent trends in development of implant coatings, Int. J. Mol. Sci. 15, 11878 (2014).
- Y. Maeda, S. Miyoshi, and T. Yamaguchi, Oval cross section metal tube producing device and producing method, February 5, 2007, U.S. Patent No. 7,219,522.
- A. Thomas, Patterned chocolate coatings, methods, and apparatus for preparing same, June 26, 2001, U.S. Patent No. 6,251,455.
- R. Hunt, Numerical solution of the free-surface viscous flow on a horizontal rotating elliptical cylinder, Numer. Methods Partial Differ. Eqs. 24, 1094 (2008).
- G. K. Batchelor, An Introduction to Fluid Dynamics (Cambridge University Press, Cambridge, 1967).
- M. A. Kelmanson, On inertial effects in the Moffatt-Pukhnachov coating-flow problem, J. Fluid Mech. 633, 327 (2009).
- W. Li, M. S. Carvalho, and S. Kumar, Liquid-film coating on topographically patterned rotating cylinders, Phys. Rev. Fluids 2, 024001 (2017).
- S. Dodds, M. S. Carvalho, and S. Kumar, Stretching and slipping of liquid bridges near plates and cavities, Phys. Fluids 21, 092103 (2009).
- K. N. Christodoulou, S. F. Kistler, and P. R. Schunk, Advances in computational methods for free-surface flows, in Liquid Film Coating, edited by S. F. Kistler and P. M. Schweizer (Springer, Amsterdam, 1997), pp. 297–366.
- R. V. Roy, A. J. Roberts, and M. E. Simpson, A lubrication model of coating flows over a curved substrate in space, J. Fluid Mech. 454, 235 (2002).
- D. E. Weidner, Suppression and reversal of drop formation on horizontal cylinders due to surfactant convection, Phys. Fluids 25, 082110 (2013).
- W. Li and S. Kumar, Thin-film coating of surfactant-laden liquids on rotating cylinders, Phys. Fluids 27, 072106 (2015).