Export citation

Export citation

Choose format for download:

Download Citation
  • Access by Xinjiang University

Partial-depth lock-release flows

M. A. Khodkar, M. M. Nasr-Azadani, and E. Meiburg

  • Department of Mechanical Engineering, University of California, Santa Barbara, Santa Barbara, California 93106, USA

Phys. Rev. Fluids 2, 064802 – Published 28 June, 2017

DOI: https://doi.org/10.1103/PhysRevFluids.2.064802

Abstract

We extend the vorticity-based modeling concept for stratified flows introduced by Borden and Meiburg [Z. Borden and E. Meiburg, J. Fluid Mech. 726, R1 (2013)] to unsteady flow fields that cannot be rendered quasisteady by a change of reference frames. Towards this end, we formulate a differential control volume balance for the conservation of mass and vorticity in the fully unsteady parts of the flow, which we refer to as the differential vorticity model. We furthermore show that with the additional assumptions of locally uniform parallel flow within each layer, the unsteady vorticity modeling approach reproduces the familiar two-layer shallow-water equations. To evaluate its accuracy, we then apply the vorticity model approach to partial-depth lock-release flows. Consistent with the shallow water analysis of Rottman and Simpson [J. W. Rottman and J. E. Simpson, J. Fluid Mech. 135, 95 (1983)], the vorticity model demonstrates the formation of a quasisteady gravity current front, a fully unsteady expansion wave, and a propagating bore that is present only if the lock depth exceeds half the channel height. When this bore forms, it travels with a velocity that does not depend on the lock height and the interface behind it is always at half the channel depth. We demonstrate that such a bore is energy conserving. The differential vorticity model gives predictions for the height and velocity of the gravity current and the bore, as well as for the propagation velocities of the edges of the expansion fan, as a function of the lock height. All of these predictions are seen to be in good agreement with the direct numerical simulation data and, where available, with experimental results. An energy analysis shows lock-release flows to be energy conserving only for the case of a full lock, whereas they are always dissipative for partial-depth locks.

Physics Subject Headings (PhySH)

Article Text

References (16)

  1. J. E. Simpson, Gravity Currents in the Environment and Laboratory (Cambridge University Press, Cambridge, 1997).
  2. E. J. Hopfinger, Snow avalanche motion and related phenomena, Annu. Rev. Fluid Mech. 15, 47 (1983).
  3. M. Ungarish, An Introduction to Gravity Currents and Intrusions (CRC, Boca Raton, 2010).
  4. E. Meiburg and B. Kneller, Turbidity currents and their deposits, Annu. Rev. Fluid Mech. 42, 135 (2010).
  5. T. von Kármán, The engineer grapples with non-linear problems, Bull. Am. Math. Soc. 46, 615 (1940).
  6. T. B. Benjamin, Gravity currents and related phenomena, J. Fluid Mech. 31, 209 (1968).
  7. J. O. Shin, S. B. Dalziel, and P. F. Linden, Gravity currents produced by lock exchange, J. Fluid Mech. 521, 1 (2004).
  8. Z. Borden and E. Meiburg, Circulation-based models for Boussinesq gravity currents, Phys. Fluids 25, 101301 (2013).
  9. C. Pozrikidis, Introduction to Theoretical and Computational Fluid Dynamics (Oxford University Press, Oxford, 1996).
  10. C. Härtel, E. Meiburg, and F. Necker, Analysis and direct numerical simulation of the flow at a gravity-current head. Part 1. Flow topology and front speed for slip and no-slip boundaries, J. Fluid Mech. 418, 189 (2000).
  11. M. M. Nasr-Azadani and E. Meiburg, Gravity currents propagating into shear, J. Fluid Mech. 778, 552 (2015).
  12. M. A. Khodkar, M. M. Nasr-Azadani, and E. Meiburg, Intrusive gravity currents propagating into two-layer stratified ambients: Vorticity modeling, Phys. Rev. Fluids 1, 044302 (2016).
  13. J. W. Rottman and J. E. Simpson, Gravity currents produced by instantaneous release of a heavy fluid in a rectangular channel, J. Fluid Mech. 135, 95 (1983).
  14. Z. Borden and E. Meiburg, Circulation-based models for Boussinesq internal bores, J. Fluid Mech. 726, R1 (2013).
  15. M. M. Nasr-Azadani and E. Meiburg, TURBINS: An immersed boundary, Navier-Stokes code for simulation of gravity and turbidity currents interacting with complex topographies, Comput. Fluids 45, 14 (2011).
  16. M. M. Nasr-Azadani, Understanding turbidity currents interacting with complex seafloor topographies: A depth-resolved numerical investigation, Ph.D. thesis, University of California, Santa Barbara, 2013.

Outline

Information

Sign In to Your Journals Account

Filter

Filter

Article Lookup

Enter a citation